Slanetrac SA1000 Finger Bar Hedge Trimmer

The SA-1000 Swivel Trim Tractor Front Loader Finger Bar allows you to convert a Front Loader quickly to a Hedge Trimmer. The SA-1000 Swivel Trim Tractor Front Loader Finger Bar Hedge Trimmer is a quick and easy system allowing you to perform neat hedge trimming. This system is connected to the tractor hydraulics so you need a tractor with a suitable hydraulic flow for it to operate properly.

Eighty horsepower upwards is recommended. The best way to do this is to bring two hydraulic hoses from the rear of the tractor and connect them to the hedge cutter. The extra auxiliary on the loader can be connected to the hydraulic ram. This allows you to move the hedge cutter from horizontal to vertical. This product has a spring break away which protects the cutting head. It is very easy to use because you are cutting straight ahead of you and the steering is very responsive to your cut. You can reach good highs with your loader and gives you a neat and even cut.
By removing one pin, you can easily swivel the head to the opposite side. This allows you to cut down behind fences and it also allows you to cut into corners. This operation is very difficult with other hedge cutters.

• Swivel head
• Cuts up to 40mm thick
• 1 Metre Cutting Width
• Works from loader Hydraulics and tractor spool valve
• Can change from right to left cutting position
• Extendable reach bar
• It Will suit anything with euro bracket fittings
• All pipes and fitting supplied
• 60l/min Oil Flow required